[[email protected]]

I can’t get my Installation of Warn Winch Vantage 3000 to work. It appears the solenoid isn’t working? Please help with the correct wiring diagram.

 

[dpdavidson02]

Welcome to the forum. What machine are you putting the winch on? Do you have a remote control with the winch?

 

[[email protected]]

Welcome to the forum. What machine are you putting the winch on? Do you have a remote control with the winch?

It’s a 2016 Artic Cat Prowler 700 HDX XT EPS

 

[dpdavidson02]

If your using the factory solenoid, then the top of the main studs are color coded. Should be Red, Black, Blue, and Yellow. Red is the battery positive, black is the battery negative, blue is winch in, and yellow is winch out. For the control wiring there is a plug near the ignition switch that will provide switched control power to the solenoid. Does this compare to what you have?

 

[JPinBLKforest]

Have a dealer installed 3000 lb Warn winch used to support snow plow. Winch worked this morning....for awhile, then started blowing 20 amp fuses one after the other. Any advice on installing higher capacity fuses/not....? Dead winch right now

JPinBLKForest

 

[JPinBLKforest]

Prowler 1000HDX

 

[dpdavidson02]

Going to a higher rated fuse may cause damage to the existing circuit. I'd look for any potential short in the circuit.

 

[ArcticFrost]

I can’t get my Installation of Warn Winch Vantage 3000 to work. It appears the solenoid isn’t working? Please help with the correct wiring diagram.

Did you get it installed? Every Warn winch I’ve purchased had a paper with the diagram. It’s pretty simple unless yours isn’t color coded?


Sent from my iPhone using Tapatalk