Arctic Cat Prowler Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I know I have to take belly pan off but is it just the 4 bolts on engine side. What is involved on the other end? The u joint on that end is going out. Any help in this matter will be greatly appreciated.
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #5 ·
I want to thank those that replied to my post. As it turned out it was 4 bolts and it slid right off the splined shaft on rear differential. One u joint dry and other has worn the joints holes some. I bought this prowler used and they must have driven it pretty hard. It’s just seeing light duty on the farm now. I am replacing the complete drive shaft as a unit. Should be good to go years to come.
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #7 ·
Again, t I want to thank those that replied to my post. After looking at it I decided to replace it with a complete new driveshaft. The rear ujoint was bad and coming out. The front joint had worn in the joint and by replacing it would not stayed tight. Again thanks.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top